Tecnologix

IXXAT CAN-repeater

IXXAT CAN-repeater

Ripetitore ISO 11898-2 opzione CAN low-speed


Per i nuovi sviluppi consigliamo di utilizzare il prodotto della serie IXXAT CAN-CR2xx.

Descrizione

The CAN Repeater is used for the galvanic isolation of two segments of a CAN network and for creating star or tree topologies. One special feature of the Repeater is that it separates a defective segment from the rest of the network so that the remaining network can continue working. After elimination of the defect, the segment is switched into the network again.

Alternative, the Repeater can be equipped with a low-speed bus interface (ISO 11898-3), allowing the operation as high/low-speed converter. Its galvanic isolation isolates both CAN segments from each other as well as from the power supply.

Specifiche

Specifiche tecniche

Display Transmit (2 green LEDs), defective segment (2 red LEDs)
CAN bus interface ISO 11898-2 with CAN choke. Screw terminals. CAN 1, CAN 2 and power supply are galvanic isolated against each other. CAN termination resistors are integrated (switchable).
Baudrate Up to 888 kbps
Delay 200 ns (corresponds ~40 m (~120ft.) bus length)
Power supply 9-35 V DC, 1.5 W typ., through terminals
Temperature range -20 ºC ... +70 ºC
Housing, size Plastic enclosure, 110 x 75 x 22 mm
Caratteristiche e Benefici

• Signal conversion between High- and Low-Speed CAN
• Cost savings due to simple wiring
• Increased system reliability
• Almost no influence on real-time behavior

Numeri ordine
1.01.0064.44000 CAN-Repeater (2 x ISO 11898-2) with galvanic isolation
1.01.0064.46000 CAN-Repeater (ISO 11898-2 to ISO 11898-3) with galvanic isolation