Tecnologix

LPC4088 Developer's Kit

LPC4088 Developer's Kit

Embedded Artists' LPC4088 Developer's Kit lets you get up-and-running quickly with the LPC4088 OEM Board.

Descrizione

Embedded Artists' LPC4088 Developer's Kit lets you get up-and-running quickly with the LPC4088 OEM Board. The LPC4088 OEM Board is equipped with NXP's Cortex-M4 based LPC4088 microcontroller suitable for a wide range of applications that requires advanced communication and high quality graphic displays.

Specifiche

LPC4088 OEM Board

Processor NXP's Cortex-M4 LPC4088 microcontroller in BGA package
Program Flash 128 MB NAND FLASH + 512 kB internal
Data Memory 32 MB SDRAM + 96 KB internal SRAM + 4 KB internal E2PROM
32-bit data bus to SDRAM (16-bit on special order)
SPIFI Memory 32 Mbit QSPI flash
Ethernet 100/10M Ethernet interface based on SMSC LAN8720 Ethernet PHY
Clock Crystals • 12.000 MHz crystal for CPU
• 32.768 kHz crystal for RTC
Dimensions 68 x 48 mm
Power +3.3V powering
Connectors 200 pos expansion connector (as defined in SODIMM standard), 0.6mm pitch
Other Buffered 32-bit databus

OEM Base Board

Connectors and
Interfaces
• 200 pos, 0.6mm pitch SODIMM connector for OEM Board
• LCD expansion connector with control signals for touch screen interface
• Expansion connector with all OEM Board signals
• Ethernet connector (RJ45)
• CAN interface & connector (provision for second CAN interface, but not mounted)
• MMC/SD interface & connector
• USB1: OTG or Host interface & connector
• USB2: Device or Host interface & connector
• Provision for NXP JN5148 RF module (former Jennic) interface (RF module not included)
• Full modem RS232 (cannot be fully used on 32-bit databus OEM boards)
• RS422/485 interface & connector
• Provision for IrDA transceiver interface (transceiver not mounted)
• I2S audio codec (mic in, line in, line out, headphone out) • SWD/JTAG connector
• Trace connector and pads for ETM connector
Serial Expansion Connector, 14-pos connector with UART/I2C/SPI/GPIO pins
Power • Power supply, either via USB or external 5V DC
• Optional coin cell battery for RTC and LED on ALARM output (coin cell not included)
Other • OEM Board current measuring
• Parallel NOR flash on external memory bus
• 16-bit register and LEDs on external memory bus
• 5-key joystick
• 3-axis accelerometer (I2C connected)
• LM75 temperature sensor (I2C connected)
• 5 push-button keys (four via I2C and one on ISP-ENABLE)
• 9 LEDs (8 via I2C and one on ISP-ENABLE)
• Trimming potentiometer to analog input
• USB-to-serial bridge on UART #0 (FT232R) and ISP functionality
• Reset push-button and LED
• Speaker output on analog output from OEM Board, or from I2S audio codec
• 160x150 mm in size