IXXAT CAN-CR110/FO

CAN / CAN FD repeater with screw terminals and fiber optic connector

The CAN-CR110/FO is used for galvanic isolation of two segments of a CAN / CAN FD network. As a special feature, the repeater separates a defective segment from the rest of the network, allowing the remaining network to continue working. After the fault has been eliminated, the segment is automatically switched back to the network. The galvanic isolation is provided for the CAN / CAN FD segments as well as for the power supply.

DisplayTransmit and defective segment (two duo LEDs, one for
each segment), Power (one LED)
CAN bus interfaceISO 11898-2 with CAN choke. Two screw terminals.
CAN variant available with and without integrated CAN termination.
CAN baudrateUp to 888 kbit/s
CAN FD bus interfaceISO CAN FD and nonISO CAN FD
CAN FD baudrate500 kbit/s (arbitration bitrate) and up to 2 Mbit/s  (flexible data rate)
Delaytyp. 300 ns (corresponds to ~60 m bus length) between the wire
connection of a FO Repeater through the fiber optic cable to the wire
connection of a second FO Repeater (not including the signal delay
time of the fiber optics, which is ~5 ns/m)
FO transmitterBroadcom HFBR 1404Z, 820 nm
FO receiverBroadcom HFBR 2402Z, 820 nm
FO line Multi-mode fiber optic line (only glass); recommended:
50/125 µm, 62,5/125 µm, also compatible with: 100/140 µm,
200 µm (pay attention to max. line length)
Max. line length between
two FO repeaters
50/125 µm: 1500 m, 62,5/125 µm: 2000 m
Power supply9-36 V DC, typ. 70 mA, max. 100 mA, through terminals
Galvanic isolation1 kV DC / 1 sec, 500 V AC / 1 min; CAN 1, CAN 2 and
power supply are galvanically isolated from each other.
CertificationCE, FCC
Temperature range -20 ºC ... +70 ºC
Housing, sizePlastic enclosure, 22.5 x 105 x 120 mm
  • Fiber optic enables transmission in areas with high electromagnetic disturbances
  • CAN and CAN FD interfaces in one device
  • Cost savings due to simple wiring
  • Increased system reliability
  • Almost no influence on real-time behavior
1.01.0210.11020CAN-CR110/FO, with bus termination resistor
1.01.0210.11220CAN-CR110/FO, without bus termination resistor
Tecnologix offre supporto gestito direttamente dal Team di sviluppo.
Non esitare a metterti in contatto con i nostri esperti.
Basta chiedere qui

Abbiamo trovato altri prodotti che ti potrebbero interessare!

Hai bisogno di aiuto per sviluppare il tuo progetto?

Con più di 25 anni di esperienza nei servizi di ingegneria elettronica ed informatica, affiancati da consulenza e formazione, Tecnologix è il partner ideale per lo sviluppo di ogni tipo di applicazione nel settore industriale.
Clicca il pulsante qui sotto e inviaci la tua richiesta, il nostro staff ti risponderà il prima possibile.