Tecnologix

ECUcore-1130

ECUcore-1130
Equipped with four CAN interfaces, Ethernet, 3 serial ports and an on-board FPGA, the ECUcore-1130 is an ideal solution for embedded control applications that require high computing power combined with high demands in networking. In combination with the PXROS-HR operating system this board is predestinated to safety critical applications.
Descrizione

Equipped with four CAN interfaces, Ethernet, 3 serial ports and an on-board FPGA, the ECUcore-1130 is an ideal solution for embedded control applications that require high computing power combined with high demands in networking. In combination with the PXROS-HR operating system this board is predestinated to safety critical applications.

Caratteristiche e Benefici

Module features:

Controller: Infineon TC1130, based on Tricore V1.2
System Clock: 150MHz
RAM: 64MB SDR-SDRAM (32MB optional)
Flash: 128MB NOR (16/32MB optional)
SERIAL FLASH : 2MB only for FPGA-Firmware
EEPROM: 32 KiB
FPGA Options: Lattice LFE2-6
Fast Ethernet: 10/100Mbps, on-board PHY
CAN: 4
UART: 3
SPI/I2C: 2/2
Operating Conditions: Temperature: -40°C…+85°C
Humidity: 10-90% RH, non-condensing
Power Supply: 3.3V +/- 4%, 1.5A max.
Dimensions/Weight: 78 x 54 x 8 (L x W x H in mm), 20g
Board-to-board connector: 3x 120 pin header socket, 0,5 mm pitch
Available on board-to-board connector: CAN, 2x I²C, 2x SPI, 2x Micro Link Interface (MLI), 3x 32bit General Purpose Timer Unit, Multi-purpose I/O signals, 2 16-bit Capture and Compare Unit (CAPCOM6), USB Device 1.1 Interface, Ethernet
RoHS compliant: yes
Operating System Support: PxROS
Integrated Development Environment (IDE): Pre-integrated Eclipse-based IDE with GNU C/C++ tool chain, source- and assembly-level debugger
Complementary Middleware: CANopen® Protocol Stack Source Code
Ethernet POWERLINK Protocol Stack Source Code